Cable structures are efficient and flexible, but their behaviour under large displacements can be strongly nonlinear. SAFI™ structural analysis provides catenary cable elements for tension-only modeling, automatic calculation of the undeformed cable length, and nonlinear analysis of cable-supported systems.
- Assign a cable-type section to a member and choose linear or catenary behaviour.
- The undeformed cable length is computed from a pretension, a minimum tension or a vertical deflection.
- Catenary cables act in tension only, with no bending, shear, compression or torsional rigidity.
- Nonlinear analysis captures all the parameters that control cable stiffness together.
Why Catenary Cable Analysis Is Nonlinear
A cable can go through large displacements before it reaches equilibrium. As the load is applied, its geometry changes significantly, and that new geometry changes how the cable carries the load.
This is why a conventional small-displacement linear analysis may not be appropriate for cable structures: it assumes the geometry stays essentially the same under load, which is not the case when a cable sags and stretches into its final shape.
Catenary Cable Modeling
To model a cable, you assign a cable-type section to a member and choose its behaviour: linear or catenary.
For catenary cables, the undeformed cable length can be calculated automatically from one of three inputs:
Tension-Only Behaviour
The catenary element works the way a real cable does. It acts only in tension, and end fixities are ignored.
- Tension
- Bending rigidity
- Shear rigidity
- Compression
- Torsional rigidity
Parameters That Control Cable Stiffness
The stiffness of a catenary cable depends on several parameters at the same time:
- Cross-sectional area
- Elastic modulus
- Undeformed cable length
- Distributed transverse load, including self-weight
- Positions of the end joints
When Nonlinear Analysis Is Required
Because all of these parameters interact, a nonlinear analysis is required to capture them together.
Verification Examples
The companion catenary cable technical paper includes verification comparisons for:
- Cables under uniform and thermal loads
- Cables under concentrated and uniform loads
- A 3D cable system with a spring
- A pretensioned cable mesh
Video: Cables in SAFI™ Software
Frequently Asked Questions
Why is cable analysis nonlinear?
Cables go through large displacements before reaching equilibrium, so their geometry changes significantly under load. A conventional small-displacement linear analysis may not be appropriate in that case.
How is the undeformed length of a cable found?
The undeformed cable length can be computed automatically from a pretension, a minimum tension or a vertical deflection that you specify.
Can a catenary cable take compression or bending?
No. The catenary element has no bending, shear, compression or torsional rigidity. End fixities are ignored and the cable acts only in tension.
Learn More
Structural Analysis
Model Cable Structures with Confidence
Tension-only catenary cables, automatic undeformed length and nonlinear structural analysis.